18FLPC Series Linear Potentiometer

Conductive Plastic Model, shaft with a ball tip and fixing nail mounting to the body

Caractéristiques principales

Industrial conductive plastic model
Measurement range: 25 mm and 50 mm
Resistance value: 500 Ω to 10 kΩ
Linearity tolerance: ±0.5%, ±0.2% and ±0.1%
Body dimensions (mm): 18x18x63 or 18x18x68

About the 18FLPC Series Linear Potentiometer

The 18FLPC has a connector block on the housing case and a shaft with a spring return device and a ball tip at the end of shaft.

In the 18FLPC Series we have the 18FLPCC25RE and the 18FLPCC50RE.

Special Specifications available

Higher resistance value (20kΩ, 50kΩ [50kΩ is available for 18FLPCC50RE only] ), Stroke 75mm (S18FLPCC75), stroke 100mm (S18FLPCC100), stroke 150mm (S18FLPCC150), stroke 200mm (S18FLPCC200), sealed type (IP54, the length of "A" is extended by abt. 12mm), with spring return device (available 75mm & 100mm stroke, friction is approx. 3N [300gf]. Spring return device is mounted on the outer shaft), with a cardan joint (without spring return device). Extra taps (available up to 1 tap and only on the version with a connector). In case of leadwire terminals, the dimensions are as the right drawing: (the dimensions of "A", "B" & "L" are the same as above table), leadwire length is 1m.

Avez-vous besoin de ce capteur pour votre prochain projet?

Demandez un devis sans engagement ou envoyez-nous vos coordonnées pour une consultation gratuite et sans engagement. Nos ingénieurs commerciaux vous contacteront dans un délai maximum de 1 à 2 jours ouvrables.

Parler à un expert

Téléchargements de produits

18flpc series linear potentiometer en

Parlez à nos experts

Vous ne trouvez pas exactement ce que vous cherchez ? Nous proposons des capteurs et des systèmes de mesure standard, mais nous pouvons également vous aider à concevoir un capteur sur mesure ou une solution de mesure complète. N'hésitez pas à nous contacter pour obtenir des conseils ou un devis.

Parler à un expert

Spécifications techniques

Spécifications	Valeur
	Precision class: ±0.2%, ±0.1%
Contact resistance variation	Within 2% C.R.V.
Dielectric strength	1 minute at 500V.A.C.
Friction	Within 3N (300gf)
Independent linearity tolerance	Standard class: ±0.5%
Insulation resistance	Over 1.000MΩ at 500VDC
Mass	Approx. 100g, approx. 150g
Output smoothness	Within 0.1% against input voltage
Power rating	0.5W, 0.75W
Resistance temperature coefficient	± 400p.p.m./°C
Resolution	Essentially infinite
Standard resistance values	500Ω, 1kΩ, 2kΩ, 5kΩ, 10kΩ
Stopper strength	Approx. 90N (9kgf)
Stroke	25mm, 50mm
Total resistance tolerance	±10%
With spring return device	Fitted (standard)