SG-KP Strain Gauge Amplifiers
Single Channel Strain Gauge Amplifier for DIN Top Hat Rail Mounting
About the SG-KP Strain Gauge Amplifiers
This single channel strain gauge amplifier SG-KP allows the supply and signal amplification of a strain gauge transducer. The connecting of the transducer which should have a full bridge resistance greater than 300 ohms, can be done in 4-wire-technology or by using a long connecting cable in 6-wire-technology. For further evaluation standard analogue outputs are available.
The measuring amplifier is installed into a plastic enclosure (IP20) which is intended for the top hat rail mounting.
The amplification can be adapted by an internal precision resistance.
The potentiometers Z (Zero) and G (Gain), which are accessible above the enclosure cover, allow a correction of the calibration. By means of an internal resistance, a change of the zero-range can be achieved.
Key features SG-KP
- Supply voltage 10 - 18 VDC / 18 - 30 VDC
- Analogue output 0 - 10 V / ±10 V / 4 - 20 mA
- Plastic enclosure (IP20) for DIN-top hat rail mounting
- Dimensions (W x H x D) 23 x 99 x 115 mm
Do you need this sensor for your next project?
Request a no-obligation quote or send us your contact details for a free, no-obligation consultation. Our sales engineers will then contact you within a maximum of 1 to 2 working days.
Product downloads
Talk to our experts
Not exactly what you are looking for? We offer standard sensors, but can also help you with sensors adapted for you or a fully customised measurement solution. Contact us for advice or pricing.
Talk to an expertTechnical Specifications
| Specification | Value |
|---|---|
| Analog output | 0 - 10 V / ±10 V, max. 1 mA (short-period short-circuit proof) 4 - 20 mA, max. 500 Ω |
| Dimensions (w x h x d) | 23 x 99 x 115 mm |
| Electrical connections | Pluggable screw clamp |
| Enclosure | Plastic enclosure for top hat rail mounting (IP20) |
| Input resistance | >3 MΩ |
| Isolating proof voltage input to output | 200 V (higher isolated proof voltage on request) |
| Limit frequency (-3 db) | 1 kHz, shiftable low-pass filter of 10 Hz per DIP-switch |
| Max. input sensitivity | 100 mV/V at ±5 VDC excitation supply |
| Non-linearity | ±0.05 % FSO |
| Number of measuring channel | 1 (full bridge resistance >300 Ω) |
| Operating temperature | 0 to +50 °C |
| Power consumption | max. 5W |
| Storage temperature | -20 to +60 °C |
| Strain gauge excitation supply | ±2.5 VDC / ±5 VDC |
| Supply voltage | 10 - 18 VDC, 18 - 30 VDC, electronics protected against voltage reversal |
| Weight | approx. 150 g |