IOLITEI-1XSTG Strain Gauge Amplifier
Fully configurable isolated strain gauge amplifier with EtherCAT bus and software support
About the IOLITEI-1XSTG Strain Gauge Amplifier
IOLITEi-1xSTG is a single channel gauge amplifier with internal quarter-, half- and full-bridge configurations. Low noise voltage and current source excitation are available with freely settable levels. Input ranges span from 50 V to 100 mV. Data is transfered over EtherCAT to a PC running powerful and easy to use DEWESoft data acquisition software.
Features
- Internal bridge completion (quarter & half, 120 & 350 ohm)
- 50 V to 100 mV input voltage ranges
- 20 mA current input range (internal shunt)
- Settable voltage and current excitation (max 400 mW) Low noise, high dynamic performance
- Signal and power isolation from EtherCAT to front-end
- EtherCAT bus, daisy-chaining with single cable up to 50 m device-device
- DEWESoft X3 software support
Applications
- Material strain measurements
- Precise weighting
- Structural load monitoring
Software support: DEWESoft X3, any standard EtherCAT master
Installation: Devices are daisy chained with a standard network cable. It is recommended that the cable is shielded (SFTP, CAT5e) and has a minimum 24 AWG wire thickness. The cable must have 4 wire pairs. The maximum distance node-to-node is 50 m.
Power supply: Passive PoE power injector is neccessary for merging the EtherCAT signal and power into a single cable.
Behöver du den här sensorn till ditt nästa projekt?
Begär en offert eller lämna dina uppgifter för att få mer information från en av våra experter.
Produktnedladdningar
Få det på ditt sätt
Inte exakt vad du letar efter? Vi erbjuder standardsensorer, men kan också hjälpa dig med en komplett skräddarsydd lösning. Kontakta oss för rådgivning eller budgetprissättning.
Prata med en expert