SG-TG-USB-3P / SG-TG-USB-4P Strain Gauge Amplifier

---

Nyckelfunktioner

• Number of measurement channels: 1 (DMS full bridge >300 Ω)
• Supply voltage: 4.75 … 5.25 VDC (USB)
• Data rate: 115,200 kbps
• Electrical connection: plug connector
• Housing: aluminum desktop housing IP50 (also available in IP65)
• 4-wire technology

---

About the SG-TG-USB-3P | SG-TG-USB-4P Strain Gauge Amplifier

The 1-channel strain gauge measuring amplifier described in an aluminum table-top housing enables the supply and signal amplification of up to 3 (or 4) strain gauge sensors connected in parallel.

Technical Description:
The described 1-channel strain gauge amplifier in the aluminum desktop housing enables the supply and signal amplification of up to 3 (or 4) parallel-connected strain gauge transducers with standardized measuring signal/
Sensitivity. To the measuring amplifier can Any strain gauge transducer with strain gauge full bridges
greater than or equal to 300 ohms. The Wiring of the transducers is carried out in 4-wire technology.

A USB interface and asuitable software available. The sampling rate can be set via the supplied software can be adapted.

Pinout:
The amplifier is connected via the connectors on the front of the device. Plug sensor (7-pin): Sensor 1, Sensor 2, Sensor 3, (optional: Sensor 4) Note: The connection sequence of the 3 (4) transducers is for a meaningful measurement result not relevant due to the summation.

 

---